Wish it would, because since it won't I have to have a separate computer to run the LS100, since you can't load 2 different Gravo laser drivers on the same computer. The new-to-me LS100 I got a few months ago has the 7.04-3 driver, the LS900 won't load it's firmware either. It's a $1200 fix, which will also upgrade the controller to accept USB input (mine is LPT or serial input only) which would be okay, but I've just lived with it since 99% of engraving I can do using Corel. Rastering is fine in Gravo, BUT, if there's any open vectors within the job area, even if not engraved, the driver will tank. The fix is to power down the machine, delete then reload the driver. The funny thing is, the driver works just fine in Corel, right up until I try vectoring in Gravo- then it won't vector in Corel either. Just keeps going until I turn the machine off. And ever since that day, if I try to vector ANYthing using Gravostyle, the driver goes TU and the gantry just creepy crawls to the right at 0 speed, sometimes laser on, sometimes off. What the hell, I ran it anyway, what could go wrong? All was okay until I tried rastering using the engrave-UP and 3200 dpi settings- the machine went bonkers, the laser head about took out the right wall of the machine at 900 mph, then headed south at about 1 speed with the laser firing full on. It happily runs Gravo 98, 5 and 5.3 and all drivers 4.06-3 and older.then I got 7-Discovery with the IS-400 P
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |